Crosswinds STOL Inc.
highly modified Piper PA-18 SuperCubs, PA-12 & 14 Cruisers, PA-20 & 22 Pacers, AmericanChampion /Citabria, Stinson, TaylorCraft, Aeroncas, Cessna and Experimental Aircraft
Home      Products

NEW! Crosswinds Inc. AquaPlaneR

Crosswinds STOL Inc. continues their tradition of innovation in flight dynamics with the introduction of the Aquaplane adaptation that gets you on step  fast. Pop out of the soup like a cork! More Information...
 
 
Crosswinds
S.T.O.L. Kit
The basic Crosswinds S.T.O.L. kit was developed to reduce or eliminate "MOOSE HUNTER STALLS", a spin initiated by an extremely uncoordinated tight turn which causes a snap roll entry into a spin which commonly happens without enough altitude to recover. The increased stability and reduced stall speed is a positive by-product of the leading edge cuff. The basic kit consist of a leading edge cuff, tip spill plates, inboard flap extensions and stol fences that seperate the air between the ailerons and flaps. More Information...

    Piper STOL Kits

    Piper PA-12 Super Cruiser

    Piper PA-14 Family Cruiser

    Piper PA-18 Super Cub

    Piper PA-20/22 Pacer/Tri-Pacer

        Citabria STOL Kits

        Bellanca Champion

        7EC & 7ECA Series

        7GC, 7GCAA & 7GCBC Series

        7KCAB Series

            Cessna STOL Kits

            170B

            180, 180A, 180B, 180C

            185, 185A, 185B, 185C, 185D, A185E, A185F

              Crosswinds S.T.O.L.'s
              Full Performance Wing

              Crosswinds S.T.O.L. with assisstance from MicroAerodynamics modifys and builds a full performance cub wing. This full performance wing has evolved from real world research and development, break throughs in engineering and shared product partnerships. Many of the modification and products this wing uses have been available since the 1970's some have just been made available in recent years. Each modification first needed to justify its existence and work in precise balance with the rest of the aircraft. The resultant wing features the the Crosswinds S.T.O.L. leading edge cuff stol kit with stall fences and wing tip spill plates. MicroAerodynamics generation II Vortice Generators enhanced specifically for use with the Crosswinds S.T.O.L. leading edge cuff. Crosswinds S.T.O.L. extended wings and Concept Wing Tips. At the trailing edge the flaps are extended outboard about 3 feet and 6 inchs inboard. The ailerons are then extended outboard to the tip approximately 2 feet. This combination adds no mechanical linkages and keeps with the simplicity of the cub wing design while maximizing wing performance and greatly reduces stall speeds, without sacrificing any roll response. More Information...
               
              All content ©2010 Webmusher/Crosswinds STOL Inc.